Serial Monitor in Particle Dev isn't working

[RWB]

@ScruffR @Arunn I had this same issue when I upgraded Photons to firmware 0.6.0 where the serial monitor app would not work in Particle Dev anymore. It would work with TeraTerm Terminal app though.

Here is what I did to get serial monitor working in Particle Dev again

No com port being assigned to my (photon) devices

@avtolstoy I ran the app to uninsall previous Photon drivers and it successfully completed. I then rebooted the machine. I tried to run the app again but it said since I’m running Windows 10 no drivers are needed. The serial monitor app in Particle Dev will not open up the Photon anymore. I used Zadig to change the drivers as shown below to get Particle Dev’s serial monitor to work with the Photon again. Should there be 2 listings when the Photon is plugged in as shown below? [image] [imag…