As the beta progresses I’ll post what’s new here.
If you already have the agent installed, run the install script again to upgrade. I recommend you accept all the prompts to replace your firmware by Tinker, then reboot to reset all pins to a known good state.
bash <( curl -sL https://particle.io/install-pi ) # Accept all setup prompts to replace your firmware by Tinker sudo reboot
December 7, 2016
- [BUGFIX] Firmware not lost on boot
November 29, 2016
Implement I2C. RPi I2C docs
Don’t set peripheral pins (I2C, SPI) as inputs at start
To use this firmware, recompile your code using the Web IDE, CLI or Dev.
- Update Tinker to not change special pins (I2C, SPI) to INPUT
- safe mode should copy tinker not move it
November 23, 2016
- automatically run
particle-agentcommands as root.
particle-agent setupis sufficient, no need for
sudo particle-agent setup.
- safe mode. Puts Tinker back if the firmware crashes 5 times within 30 seconds.
If you already have the agent installed, run the install script again to upgrade. Press Ctrl-C at the Particle Cloud setup prompt if you don’t want to replace your running firmware by Tinker.
bash <( curl -sL https://particle.io/install-pi )