Error 500 when trying to flash Raspberry Pi 3

[jvanier]

@carbuthn

I enabled I2C, and everything came to a stop

I2C support had not been added yet. It's now in there. If you want to try again, see the changelog for instructions and make sure you reboot after updating the agent to reset pins to a known good state.

Raspberry Pi Changelog

As the beta progresses I’ll post what’s new here. If you already have the agent installed, run the install script again to upgrade. I recommend you accept all the prompts to replace your firmware by Tinker, then reboot to reset all pins to a known good state. bash <( curl -sL https://particle.io/install-pi ) # Accept all setup prompts to replace your firmware by Tinker sudo reboot December 7, 2016 particle-agent release 0.2.3-1 [BUGFIX] Firmware not lost on boot November 29, 2016 firmware …