Photon does not execute application

I am using Netbenas and cywin for local bulding.
Building goes ok, and so good goes flashing firmware.
The same should be doen for application flsh but photon does not seems to execute it.
No command in applicatiosn does something at runtime,
photon just goes to cloud connect even if SYSTEM MODE is set to MANUAL through application.
If SYSTEM MODE is set to MANUAL in firmware photon is flashing white and that is all.

I moved 6 posts to an existing topic: Photon Firmware Upload and photon does not restart

Seeing as this thread was basically a continuation of the one I moved these posts to, there wasn’t really a reason to open a new thread. Keeping things together will make it easier to debug any issues. If the information gets spread too much, it’ll get more confusing than it needs to be.

This topic was automatically closed 27 minutes after the last reply. New replies are no longer allowed.