Hello, I have installed 4 times the same Xenon (reset, new flash, factory reset, etc…) to come back to the initial setup again (blink blue) and went through the setup over the app without much problem to pair the xenon with an existing Argon (breathing Cyan, no issue) The issue is that after the X…

So when you do not use your xfinity router you have the correct behaviour - that is good news and hope at least. Perhaps my router has a similar issue despite it not being xfinity and despite the fact that I disabled ip6. I’ll find another old router to test…

That’s right. And I didn’t disable anything in the Xfinity one, just put another in between. It has to serve DNS

Seeing this same issue. Definitely not an Xfinity router, but likely using IPV6. The Argon works fine and can be controlled via Tinker, but the associated Xenon completes its initial handshake and never reaches the device cloud again.

So I just did an experiment, I have a working breathing cyan mesh network, using my ethernet featherwing thru my Apple Time Capsule router. This router is connected by ethernet to the Xfinity router, but makes it’s own network, both ethernet and wifi. If I move the Ethernet Featherwing to the xfin…

Experienced the same issues here.

Apparently, the same discussion is also taking place here: [image] What does xenon fast flashing green mean? BLE // NFC I am now having my first experience with a Xenon in fast blinking green. I put a Xenon endpoint one floor down in my office/warehouse. It is sitting in …

Hi all – thanks for sharing details of the issues you’re experiencing. Our engineering team is working on identifying fixes, but in the meantime I just wanted to let you know that we’re on it and we’ll get back to you with next steps soon.

[image] jimbol: I don’t know if that’s really helpful to anyone, but it is one more piece of info for you green-flashers. There is a known issue with Xfinity routers for which we have already produced a firmware fix for and will release in rc.26 as quickly as possible. Thank you for your pati…

[workaround for always fast flashing green found for me] I found an old Dlink DIR 505 “All In One Mobile Companion” (with modes as router, hotspot, etc.) I put it in Router mode between by Linksys WRT1900AC and the argon gateway and the xenon’s have all been breathing cyan ever since. If it was …

@jtmoderate876 , another member mentioned that disabling IPv6 doesn’t always actually disable on some routers!

Xenon blinking green after breathing cyan

Connectivity BLE // NFC

ninjatill November 29, 2018, 6:04pm 18

Apparently, the same discussion is also taking place here:

Topic		Replies	Views
What does xenon fast flashing green mean? BLE // NFC	39	5852	December 7, 2018
Xenons not making Cloud Connection via mesh BLE // NFC	22	3997	December 4, 2018
Xenons start flashing green BLE // NFC	1	667	November 29, 2018
Xenon mesh unstable BLE // NFC	19	2228	November 19, 2018
Mesh: issue with certain? Xfinity routers Troubleshooting	28	4779	December 15, 2018

Xenon blinking green after breathing cyan

Related topics