Tutorial: Using Eclipse + ST-LINK/v2 + OpenOCD to debug

Getting Started
33

@mtnscott, I am getting similar errors except on Windows 7x64. If I don’t hold RESET then I get the same thing that @omidontop got. If I hold reset,run the debugger and hold reset, I get this:

GNU ARM Eclipse 64-bit Open On-Chip Debugger 0.8.0-00063-gbda7f5c (2015-01-31-18:41)
Licensed under GNU GPL v2
For bug reports, read
	http://openocd.sourceforge.net/doc/doxygen/bugs.html
srst_only separate srst_nogate srst_open_drain connect_deassert_srst
Started by GNU ARM Eclipse
Info : This adapter doesn't support configurable speed
Info : STLINK v2 JTAG v23 API v2 SWIM v4 VID 0x0483 PID 0x3748
Info : using stlink api v2
Info : Target voltage: 3.232461
Info : stm32f1x.cpu: hardware has 6 breakpoints, 4 watchpoints
Info : accepting 'gdb' connection from 3333
Info : device id = 0x20036410
Warn : STM32 flash size failed, probe inaccurate - assuming 128k flash
Info : flash size = 128kbytes
undefined debug reason 7 - target needs reset
Error: timed out while waiting for target halted
TARGET: stm32f1x.cpu - Not halted

in procedure 'reset'
Info : Halt timed out, wake up GDB.
Error: timed out while waiting for target halted
in procedure 'halt'
semihosting is enabled
Error: timed out while waiting for target halted
TARGET: stm32f1x.cpu - Not halted

in procedure 'reset'

Error: Target not halted
Error: failed erasing sectors 0 to 7
Error: flash_erase returned -304
Info : dropped 'gdb' connection
I also get the pop-up error:

I also get this pop-up error:

1 Like