A few years back there was a similar discussion on this forum which also suggested to use some Goretex like air vents.
Hello Particle Community,
I left 2 devices in their enclosures out in the sun during the day and it was hot enough to deform my PLA enclosures. I pulled them back in out of the hot sun and I was happy to see that the devices were still working, but over the next week I noticed that the devices started to loose power and come right back on.
It looks like someone is pulling the power and immediately reconnecting it. Perhaps the day in the sun caused permanent damage? This happened on 2 devices …
The Pelican cases pressure relief valve is supposed to be like Goretex where it allows air in and out but will not allow water to pass which allows them to call them waterproof cases.
But that has to be where the condensation comes from.
2 Likes