Hi, my particle photon works for maybe 24hr-48hr before it starts to flash. I have looked up the sos codes but I can not see any pattern in it.

sorry, was a bit rushed to post. basically sending a serial command to my boiler every second. receiving a reply, Putting the information into an array, then using blynk to display that information. I am new to c++ and in that sort of awkward stage were I know just enough to get myself in to trouble…

is it that bad? what does the fast red flashing even mean?

This frantic red blink is no known error code, so there is definetly something very fishy, but I can’t really see anything in your code that would cause that behaviour. So my next guess would be something wrong with the Blynk functions, but that’d be a big task to find. Although slowing down your T…

@mehran , it seems that the IDE library for Blynk (0.3.2)is not matching the version on their github (0.3.3) even though the IDE version history says otherwise. The reason I know is that BLYNKSIMPLESPARKCORE.H is not in the new library. I will post a message on the Blynk forum. I am not sure why y…

Constant Fast flashing red LED fault after 24-48 hr uses

Troubleshooting

Moors7 February 9, 2016, 11:07am 2

If you could share the code you’re running, that might help.

Fast red flashing light...what does that mean?

Topic		Replies	Views
Fast red flashing light...what does that mean? Troubleshooting	7	2901	April 13, 2016
Photon flashing white (cyan) with 2-3 orange flashes intermittently (1-3 minutes) Troubleshooting	10	1505	July 4, 2017
Photon flashing blue after a few minutes Troubleshooting	2	775	November 27, 2016
Boron Flashes red 10 times Firmware	9	658	March 14, 2021
Photon flashing red! Troubleshooting	13	3906	April 24, 2018

Constant Fast flashing red LED fault after 24-48 hr uses

Related topics