Hi, I have a problem, when i go to the new wifi How can I auto turn to the listen mode after 5 minutes if not connect to wifi Thanks

[image] Go into listening mode if no known networks are available Firmware Yes. Adding WiFi.disconnect() fixes it. #include "Particle.h" #include "softap_http.h" SYSTEM_MODE(MANUAL); SYSTEM_THREAD(ENABLED); WiFiAccessPoint ap[5]; int found; /* SoftAP Stuff Ommitted */…

By looking in the docs you might have found these https://docs.particle.io/reference/firmware/photon/#listen- https://docs.particle.io/reference/firmware/photon/#ready- https://docs.particle.io/reference/firmware/photon/#system-thread

You can use SEMI_AUTOMATIC, but SYSTEM_THREAD(ENABLED) should be enough to ensure your code is running even when disconnected and hence being able to check connection status and enter Listening Mode. But I’m usually going SEMI too - just for safe measure.

SYSTEM_THREAD(ENABLED); uint8_t retry_count = 0; void setup() { WiFi.on(); } void loop() { WiFi.connect(); if(!WiFi.ready()){ retry_count += 1; } if ((retry_count >= 100)&&(WiFi.ready() == false)) { WiFi.listen(); } if (WiFi.re…

Auto enter the listen mode

Getting Started

nrobinson2000 April 6, 2017, 1:46pm 6

Topic		Replies	Views
Automatically enter and exit listening mode Firmware	7	1519	April 25, 2020
Enter listening mode after failed WiFi connection Firmware	9	1111	March 20, 2018
Go into listening mode if no known networks are available Firmware	19	4705	January 15, 2019
Make Particle Photon go into listening mode when no wifi is found General	7	1417	May 24, 2018
Is it possible to stop launching softAP if the P1 is unable to connect to a WiFi network? Firmware	10	1552	June 19, 2017

Auto enter the listen mode

Related topics