Good day all: We need to publish when our building line power drops out, and publish again when it comes back. The plan is to power a relay that takes a digital pin High with power failure, Low with good power. Simple project, but no luck with the following code. Any suggestions would be terrific! …

Electron reading digital pin state help request (novice)

ScruffR Split this topic February 27, 2018, 1:27pm 3

Some discussion about formatting code blocks in posts

Topic		Replies	Views
Basic IF statement errors Getting Started	1	2983	June 11, 2017
Struggling with my code Firmware	2	935	April 18, 2016
Reading Pins via Loop: Good or Bad Idea General	10	2052	July 8, 2016
Basic Power Loss Detection - Electron Firmware	17	7218	January 8, 2018
Button turning on and off a relay Troubleshooting	4	623	April 5, 2019