Adafruit BME280 library [PORTED]

Firmware Libraries
20

@armor
Thank you, the WEB IDE is much easier. Thank you i followed your instructions and copied the following code into my project:

#include "Adafruit_Sensor.h"
#include "Adafruit_BME280.h"

#define BME_SCK D4
#define BME_MISO D3
#define BME_MOSI D2
#define BME_CS D5

#define SEALEVELPRESSURE_HPA (1013.25)

Adafruit_BME280 bme; // I2C
//Adafruit_BME280 bme(BME_CS); // hardware SPI
//Adafruit_BME280 bme(BME_CS, BME_MOSI, BME_MISO,  BME_SCK);

void setup() {
  Serial.begin(9600);
  Serial.println(F("BME280 test"));

  // if (!bme.begin(0x76)) {
  if (!bme.begin()) {
    Serial.println("Could not find a valid BME280 sensor, check wiring!");
    while (1);
  }
}

void loop() {
    Serial.print("Temperature = ");
    Serial.print(bme.readTemperature());
    Serial.println(" *C");

    Serial.print("Pressure = ");

    Serial.print(bme.readPressure() / 100.0F);
    Serial.println(" hPa");

    Serial.print("Approx. Altitude = ");
    Serial.print(bme.readAltitude(SEALEVELPRESSURE_HPA));
    Serial.println(" m");

    Serial.print("Humidity = ");
    Serial.print(bme.readHumidity());
    Serial.println(" %");

    Serial.println();
    delay(2000);
}

The above code compiled in the web ide will try to flash it to my photon later today, thank you again.

But how did you end up with the code you showed above?
Since you added this code to the project
SYSTEM_MODE(MANUAL);
do i need to remove it before i flash the code to the project?
Also why did you remove the following:
#define BME_SCK
#define BME_MISO
#define BME_MOSI